Calculated-industries 6270 User Guide Uživatelský manuál

USER’SGUIDEAreaTake - Off Tooland Digitizing SystemModel#6260

GETTING STARTEDOnce assembly and setup are complete, proceed with the following steps in order to begin measuring.1. When placing the bars and securin

Right-Hand Confi guration ShownUSER’S GUIDE — 9

[END] Ends polyline measurement, displaying the total perimeter. Also ends the 2-Point Circle measurement when measuring a diameter, displaying the ci

[ON/CLEAR]Turns the unit ON and clearsthe display. Holding down the[ON/CLEAR] key for 1.5 seconds also powers the unit off. [CLOSE +]Completes the Pol

[UNDO]Undoes the previous measurement. Allows you to undo the last 10 measurements (if applicable) while in measure mode. If a measurement has been cl

[PC SEND]When connected to a PC, sends the value on the main display in decimal format to the PC (see PC Interface section). [ARC/CIRC]First press ide

[MODE]Used to select from the list of available modes (see Built-In Scales section).[SET] [MODE]Used to move back through the list of available modes.

[UNITS]Used to select from the list of available units of measurement (see Units of Measurement section).[SET] [UNITS]Used to move back through the li

TABLE OF CONTENTS INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1SETUP . . . . . . . . . . . . . . . . . . .

INTRODUCTION The Ultra Scale Master Prohas been specifi cally designed for residential and light commercial builders and contractors requiring area and

SETUPPACKAGE CONTENTSYour package contains the following pieces:Female End Cap2 — ULTRA SCALE MASTER® PROLong Refl ector BarUSB CableUltra Scale Master

User’s Guide,Quick Reference Guide,and Quick Setup SheetMale End CapUSER’S GUIDE — 3Short Refl ector BarLong Refl ector BarCarrying Case

RIGHT-HAND ASSEMBLYAssemble the refl ector bars as shown. Align the corner connector at a 90° angle at the top left corner of the plans.5. Slide Female

4. Insert the Male End Cap into the female end of the Short Refl ector Bar. The Male End Cap is preinstalled for a Right-Hand confi guration.3. Insert t

NOTE: Sloping side of the Refl ector Bars face outward.5. Insert the the male end of the second Long Refl ector Bar into the female end of the Short Refl

FINAL ASSEMBLYThe ultrasonic beams are sent from the right arm of the Puck to the top bar, then refl ected back, and from the left arm of the Puck to t